Part 1 – Introduction
9
I/O Device Port
1
4
5
2
3
1
Network Port
2
Audio In
3
Audio Out
4
Alarm In
5
Alarm out
•
Network Port
Connect a network cable with an RJ-45 connector to
this port. If using a PoE switch, you can supply power
to the camera using an ethernet cable. For more
information on PoE switch use, refer to the switch
manufacturer's operation manual. You can configure,
manage, and upgrade this camera and monitor its
images from a remote computer over the network.
For more information on network connection setup,
refer to the
IDIS Discovery operation manual
.
The following table describes the network cable
specifications.
<The network cable specifications>
Item
Content
Note
Connector RJ-45
Ethernet
10/100 Base
10/100 Mbps
Cable
UTP Category 5 or
higher
Maximum
length
100m
PoE
IEEE 802.3af, Class 3
•
Audio In
DC-Y6516X model only
Connect an audio source to this port (line in). A built-
in microphone is featured on the front.
•
Audio Out
DC-Y6516X model only
Connect an amplifier to this port (line out). This device
does not feature a built-in audio amplifier unit and
therefore requires the user to purchase a separate
speaker system with a built-in amplifier.
•
Alarm In / Out
-
In
: Connect an alarm-in device to this port.
(Mechanism: Choose between an NC (Normally
Closed) type or an NO (Normally Open) type)
→
Connect a mechanical or electrical switch to the
alarm in port and the GND (ground) connector.
Alarm in range is 0V to 5V. In order to detect alarm
input from an electrical switch, the signal must be
higher than 4.3V from an NC switch or less than
0.3V from an NO switch and must last for longer
than 0.5 seconds.
-
Out
: It is the BJT (Bipolar Junction Transistor) - open
collector output. If the voltage and current exceed
the specification limit (Max. load: 30mA, Max.
Voltage: 5VDC), the product could be damaged.
When connecting the device which exceeds the
specification limit, refer to the picture (circuit)
below.
If used with an external inductive load(e.g. relay), a
diode must be connected in parallerl with the load
for protection. Otherwise, the product could be
damaged.
Check your local laws and regulations on making video
or audio recordings. The user will be held liable for any
violation of the law.
