Part 1 – Introduction
13
2
Insert a SD memory card into the SD memory card
slot with the 'micro SD' print facing upward.
micro
SD
Push the SD memory card until it disengages from the
slot, and then pull it out.
3
Cover the lens rear side' cover and tighten the
screws clockwise.
Make sure that the lens rear side's cover is joined
properly when screwing it; otherwise, the IP66 level is
not guaranteed.
Installation
• Check the wall or ceiling to see if it needs to be
reinforced. The camera may fall off if the wall or
ceiling is not strong enough to support its weight.
• Install the camera in a shaded area. If the camera is
installed in direct sunlight, it may affect adversely.
Bracket
Mount Adapter
Cable
1
Make a cable hole in the wall or ceiling.
2
Screw a bracket to the wall or ceiling. Ask your
dealer or distributor about the bracket.
The bracket must be purchased separately.
3
Assemble the mount adapter to the camera body
and secure it by using the mount adapter screws (3
points).
4
Hook the safety wire of the camera on the safety
wire ring of the bracket.