Part 1 – Introduction
9
•
Mount Bracket
This bracket can be installed on either top or bottom
of the camera. Use 1/4–20 UNC (20-thread), 2.5mm
+/- 0.2mm (ISO standard) or 0.197 (ASA standard)
screws to attach the mount.
•
SD Memory Card Slot
Pull on the connection cover and then insert a
microSD memory card into the slot. (An SLC (Single
Level Cell) or MLC (Multi Level Cell) card by SanDisk
or Transcend is recommended)
•
Do not remove the SD memory card while the
system is in operation. Removing the card while
the system is in operation can cause the system
to malfunction and/or corrupt data stored on
the SD memory card.
•
An SD memory card is a consumable product
with a finite service life. Prolonged use will
damage the card's memory sectors and result
in data loss or memory card failure. Test the SD
memory card regularly and replace it whenever
necessary.
Top
A
lar
m
GND 3
2
1
OUT
IN
RS485
-
8
9
+
Audio
GND
GND
3
2
2
1
OUT
IN
1
2
3
4
1
RS485 Port
2
Audio I/O
3
Alarm I/O
4
Factory Reset Switch
•
RS485 Port
Connect a pan/tilt driver to this port. Connect the
driver's TX+/RX+, TX-/RX- to the network camera's
+/—. For more information on RS485 connections,
refer to the pan/tilt driver manufacturer's
operation
manual
.
•
Audio I/O
-
Out
: Connect an amplifier to this port (line out).
This device does not feature a built-in audio
amplifier unit and therefore requires the user to
purchase a separate speaker system with a built-in
amplifier.
-
In
: Connect an audio source (line in). A built-in
microphone is featured on the front.