Part 1 – Introduction
13
Power Connector
DC12V +
Power connection (Check + and -
markings)
DC12V -
FGND
Frame grounding
Installation
The lens must be purchased separately. If you'd like
to purchase a lens, contact your camera retailer. This
camera supports manual iris lenses, DC type auto iris
lenses, and P-iris lenses in either CS-mount or C-mount
format.
•
Product color and design may vary depending on
the model.
•
We recommend megapixel lenses for clearer and
higher resolution images.
•
Video type auto iris lenses are not supported.
•
Use a lens that weighs less than 450g. Heavier
lenses can cause the camera to lose its balance.
•
Change the setting of iris mode when installing
P-iris lenses.
•
Check the wall or ceiling to see if it needs to be
reinforced. The camera may fall off if the wall or
ceiling is not strong enough to support its weight.
•
Install the camera in a shaded area. If the camera
is installed in direct sunlight, it may be affected
adversely.
Manual Iris Lens
1
Remove the protective cover from the camera.
2
Turn the lens in clockwise direction and mount it on
the camera.
3
Rotate the lens' iris ring to open up the iris and then
adjust accordingly.
DC Type/P Type Auto Iris Lens
1
Solder on the lens connection line to the connector
socket, if necessary. For more information about
soldering on the lens control wire, refer to the lens
manufacturer's
operation manual
.
1
Connector Socket
Cover
2
Iris Control Cable
3
Connector Socket
4
Heat-Shrinkable
Tube
PIN Name (DC)
Name
(P)
1
Brake (Damp)
Coil -
A +
2
Brake (Damp)
Coil +
B +
3
Drive Coil +
B -
4
Drive Coil -
A -
