iDirect iQ Desktop+, Инструкция по установке, поддержке и обслуживанию

Страница: 40 / 52

28 Installation, Support, and Maintenance Guide
iQ Satellite Router
Coax Cable Preparation
Figure B-3. Procedure to Cut the Quad Shield Cable
5. Flare the inner, outer braids and the outer foil shield only. Do not flare the inner foil
shield (last foil around dielectric).
6. (If using a coax stripper, skip this step.) Being careful not to cut into the copper of the
center conductor, remove the foil and cut the dielectric to the length shown under
Length B in Table B-1 on page 27 . Remove any dielectric residue.
7. If the conductive foil is burred, then smooth out the burr so that the edge (area where the
dielectric material was removed) is smooth and provides a lead-in for the connector
mandrel.
8. Install the RG-6 connector compression sleeve, or mandrel, (top left (A) in Figure B-4 )
over foil and underneath the braid. A good, weatherproof outdoor connector mandrel
should have a visible O-Ring (bottom right (B)
Figure B-4 ).
NOTE: The white colored inner dielectric insulation should be flush with the inner
rear surface of the connector. Refer to the picture on the right (C) in Figure B-4
for an RG-6/RG-11 termination.