iDirect Evolution X1, Руководство по установке

Страница: 45 / 130

iDirect Satellite Router Installation and Commissioning Guide 29
iDX Release 3.3
6 Configuring TRANSEC
ACC Keys
This chapter describes how to configure the Satellite Router for operation with TRANSEC
transmission security. Perform the procedures in this section only when commissioning the
Satellite Router in a TRANSEC network.
This chapter includes the following sections:
•
“Prerequisites” on page 29
• “Loading ACC Keys” on page 30
6.1 Prerequisites
Before a newly-commissioned remote can acquire a TRANSEC network, the following two
conditions must be met:
•
If an X.509 certificate has not yet been issued for the remote, then authentication must
be disabled for the remote at the hub, and in the remote options file.
• The current Network Acquisition Keys (ACC Keys) must be resident on the Satellite Router.
6.1.1 Commissioning without an X.509 Certificate
If the Satellite Router is not yet certified for the TRANSEC network, authentication must be
disabled in the options file loaded in the previous chapter. Follow the steps below only if the
remote does not yet have an X.509 certificate:
To Disable Authentication:
1. Verify that the following parameter is set to 0 in the options file:
auth_level_required = 0
2. If
auth_level_required = 1
, use a text editor to change it to 0, and save the file.
3. Load the modified options file on the Satellite Router.
4. Coordinate with the Network Operator to select Disable Authentication on the iBuilder
Remote Information tab, and to apply the hub-side changes.
Authentication is now disabled on the Satellite Router, and at the hub.