Idex Hale Sam, Техническое руководство

Страница: 97 / 223

77
Refer to Table 32 for a list of tools and/or consumables required for this procedure.
Table 32. Discharge Valve Pressure Sensor Tools And Consumables List
Standard Tools Special Tools Consumables
PPE (Eye and Hand Protection) None Shop Rag(s) (As Required)
Wire Cutter Cable Ties (As Required)
3/4-in Wrench Loctite 580 (Or Equivalent)
(Optionally, 3/4-in Extra Deep
Socket and Driver)
Pressure Sensor
<See FSG-PL-01506, TRANSDUCER,
Sheet 1>
AB Factory Cable
If an AB swing-out valve pressure sensor fails or is damaged; replace the sensor as follows.
Removal
A.
Open SAM panel(s).
B. Note cable tie locations, cut ONLY ties required to R&R pressure sensor.
C. At sensor, tag and disconnect electric connector.
D. Using 3/4-in wrench, remove sensor.
Installation
A.
Apply Loctite 580 to threads of new sensor.
(Use sealant sparingly to prevent sensor damage.)
B. Install sensor.
NOTE
Do NOT overtighten pressure sensor.
C. Hand tighten sensor until snug.
D. Using 3/4-in wrench, torque an additional 1/4 turn.
NOTE
Sensor is rated to 300 psi (~21 bar).
DO NOT EXCEED OPERATING PRESSURE LIMITS OF PUMP, INSTALLED PLUMBING,
HOSE(S), OR EQUIPMENT IN USE.
E. Connect electric connector according to tags.
F. Install cable ties cut to R&R sensor as noted.
G. Pressurize system to check for leaks.
H. Using SAM Control Center, perform pressure calibration. (See paragraph 5.2.2.1,
page 177.)
I. Close SAM panel(s).