Idex Hale Sam, Техническое руководство

Страница: 163 / 223

143
NOTE
The magnet must be touched to the face of the ITL-40 straight on and from at least a
couple of inches away and be removed in the same way (but opposite direction) the
same distance. Sliding the magnet from side to side without lowering and lifting it
straight on and off a couple of inches each time will NOT work.
B. Using a magnet, touch appropriate white dots (see red circles on Figure 118) in
sequence to enter a LRRRLLLL command string.
4.12.6.2 Foam Tank A
For current production, all ITL-40 addresses are set by the SAM software. If the ILT-40 was NOT
provided directly by Hale performing the following may allow the ITL-40 to communicate with
SAM.
A.
Power SAM system on.
NOTE
The magnet must be touched to the face of the ITL-40 straight on and from at least a
couple of inches away and be removed in the same way (but opposite direction) the
same distance. Sliding the magnet from side to side without lowering and lifting it
straight on and off a couple of inches each time will NOT work.
B. Using a magnet, touch appropriate white dots (see red circles on Figure 118) in
sequence to enter a LRRRLLLR command string.
4.12.6.3 Foam Tank B
The foam tank B ITL-40 address is set manually for the SAM system. Perform the following for
the ITL-40 to communicate with SAM.
A.
Power SAM system on.
NOTE
The magnet must be touched to the face of the ITL-40 straight on and from at least a
couple of inches away and be removed in the same way (but opposite direction) the
same distance. Sliding the magnet from side to side without lowering and lifting it
straight on and off a couple of inches each time will NOT work.
B. Using a magnet, touch appropriate white dots (see red circles on Figure 118) in
sequence to enter a LRRRLRRR command string.
4.13. Updating The Tablet After SAM Setup/Configuration Changes
Changes to Quicksets or other SAM customizable/configurable items (valve names and colors,
foam presets, etc.) must be updated for the tablet or the changes made on a SAM Control Center
will not appear on the tablet screens. To update the tablet, perform the following.
A.
Touch System Options button (or touch and hold if loading icon appears, see Fig-
ure 119). System Options screen (Figure 120) is displayed.
Figure 119. System Options Loading Icon
B. When System Options screen (Figure 120) displays, enter BAM/Wi-Fi password.
(This password is ONLY available via attending the Hale SAM Training course.)