Idex Hale Sam, Руководство по эксплуатации, установке и обслуживанию

Страница: 72 / 141

56
D. Verify Pump Controller display transitions to Pump Controller read only screen
(Figure 31).
The SAM system is powered on and ready for mode selection.
6.1.2
Mode Selection Verifications
The SAM system defaults to Auto Mode at power on with pump engaged as described below. If
Manual Mode is desired the operator must switch to it as described in paragraph 6.1.2.2, Switch-
ing To SAM Manual Mode.
6.1.2.1
SAM Auto Mode
If the apparatus is ready to pump (parking brake engaged, in pump gear, transmission in
drive/fourth gear & lockup) the system displays the Auto Mode Home screen (Figure 19) and the
SAM IS ACTIVE screen (Figure 31), otherwise, the system displays the SAM Control Center land-
ing screen (Figure 18) and the Pump Controller boot screen (Figure 30) until the apparatus is
made ready to pump. See Section 6.3 (page 65) for SAM operation.
6.1.2.2
Switching To SAM Manual Mode
Manual Mode can be accessed at any time. However, the default SAM Control Center is the land-
ing screen (shown on left-side of Figure 56) until the pump is engaged or the Auto Mode Home
screen (shown on right-side of Figure 56) when the pump is engaged.
Figure 56. Entering Manual Mode (From Landing or Home Screen)
No matter which screen is displayed, touch the MANUAL MODE button (orange) and then touch
YES (to confirm–see Figure 57) to access SAM Manual mode. See Section 6.3 (page 65) for SAM
operation.
Figure 57. Popup Confirm/Deny (Yes/No) Buttons