IDEC SmartAXIS Touch FT1A Series, Руководство пользователя

Страница: 652 / 1232

5 Multi-Command
11-36
SmartAXIS Touch User’s Manual
Properties of Word Write for Multi-Functions dialog box
Sets the Word Write command for the Multi-Command.
■
Command Name
Enter a name for the command. The maximum number is 20 characters.
■
Action Mode
Select the action to perform when the trigger condition is satisfied from the following:
■
Data Type
Select the data type handled by the operation selected for Action Mode .
For details, refer to Chapter 2 “1.2 Available Data” on page 2-2.
BIN16(+) and BIN32(+) can only be set if Action Mode is set to OR , AND , or XOR .
■
Source 1
Specify the source word device.
Click to display the Device Address Settings dialog box. For the device address configuration procedure, refer to
Chapter 2 “5.1 Device Address Settings” on page 2-62.
This setting is enabled only if
Action Mode is set to Add , Sub , Multi , Div , Mod , OR , AND , or XOR .
Set: Writes a fixed value to the specified word device when the trigger condition is satisfied.
Move: Writes the value in the source device to the destination word device when the trigger
condition is satisfied.
Set ON & OFF Data: Writes a fixed value of ON Data to the specified word device when the trigger condition is
satisfied.
Writes a fixed value of OFF Data to the specified word device when the trigger condition is no
longer satisfied.
Add, Sub, Multi, Div, Mod, OR, AND, XOR:
Performs arithmetic on the value in a source device and a fixed value or a value of device, and
writes the result to a word device when the trigger condition is satisfied.
For details about the Action Mode , refer to “Action Mode” on page 11-12. However, Set ON & OFF Data
for the Multi-Command has the same function as Momentary for the Word Write Command.
BIN16(+) and BIN32(+) can only be set if Action Mode is set to Move . Because the number of devices
to transfer is specified in Advanced mode, you do not need to set Data Type.
If BCD4 , BCD8 , or float32 is selected and the arithmetic data contains a value inexpressible in BCD, a 1
is written to System Area 2 Arithmetic error bit (2, bit 5) and an error message is displayed.
For details, refer to Chapter 3 “ Arithmetic error” on page 3-25.