IDEC Micro HG4G Series, Инструкция

Страница: 38 / 72

2
●
Prevent the HG4G/3G, HG2G-5F from falling while moving or transporting, otherwise
damage or malfunction of the HG4G/3G, HG2G-5F will result.
●
Use the product within the environmental limits given in the catalog and manual. Use of the
product in high-temperature or high-humidity environments, or in locations where it is
exposed to condensation, corrosive gas or large shock loads can create the risk of
electrocution and fire.
●
The HG4G/3G, HG2G-5F is designed for use in pollution degree 2. Use the HG4G/3G,
HG2G-5F in environments of pollution degree 2. (based on the IEC60664-1 rating)
●
Install the HG4G/3G, HG2G-5F according to the instructions in the User
’s Manual.
Improper installation will result in falling, failure, electrical shock, fire hazard, or
malfunction of the HG4G/3G, HG2G-5F.
●
Prevent metal fragments or wire chips from dropping inside the HG4G/3G, HG2G-5F
housing. Ingress of such fragments and chips may cause fire hazard, damage, and
malfunction.
●
Use a power supply of the rated value. Using a wrong power supply may cause fire
hazard.
●
The HG4G/3G, HG2G-5F
uses “PS2 of EN61131” as DC power supply. (based on the
IEC/EN61131 rating)
●
Use wire of a proper size to meet the voltage and current requirements.
●
When exporting the HG4G/3G, HG2G-5F to Europe, use an EN60127 (IEC60127)
approved fuse on the power line outside the HG4G/3G, HG2G-5F.
●
When exporting the HG4G/3G, HG2G-5F to Europe, use an EU-approved circuit protector.
●
Make sure of safety before starting and stopping the HG4G/3G, HG2G-5F. Incorrect
operation of the HG4G/3G, HG2G-5F may cause mechanical damage or accidents.
●
Use the HG4G/3G, HG2G-5F in a local area network if you download, upload or monitor the
project data via the Ethernet port.
●
The touch panel of the HG4G/3G, HG2G-5F is made of glass, and will break if exposed to
excessive shock. Take due care when handling it.
●
When more than one button is pressed at the same time, due to the detection
characteristics of an analog type touch panel, only the gravity center of the pressed area
is sensed and the unit assumes that only one button is pressed. Thus, don't operate the
HG4G/3G, HG2G-5F by pressing more than one button simultaneously.
●
Although the screen will not be visible if the backlight burns out, the touch panel will remain
functional. Incorrect touch panel operation will occur when operating the touch panel when
the backlight appears to be turned off but is actually burnt out. Because such erroneous
operation could result in damage, the touch panel should not be used after the backlight
has burned out.