5 KW2D Series Smart RFID Reader Functions
1-4
KW2D Series Smart RFID Reader User’s Manual
●
Read UID Function
The KW2D Series Smart RFID Reader is equipped with an RFID antenna (13.56 MHz band) and can read the UID of
the KW2D special tag and the general-purpose card type RFID tag.
The following IC tag standards are supported.
●
UID Verification Function
This function verifies the UID in the RFID tag against UIDs that were registered in advance. UIDs are registered on the
Tag List
tab in KW RFID Configurator. Since a 1-byte authority (1 to 255) can be specified for each UID, the UID to
be registered can be distributed to 255 types of authority. A maximum of 500 items of tag information can be
registered.
The tag information obtained in verification can be read by the host device and used to restrict the operation of
equipment and to manage the usage history.
Tag Information Contents
●
Status Confirmation Function
The operating status and error status of the KW2D Series Smart RFID Reader can be checked with the buzzer and the
LED indicators (white, green, and red) on the front of the KW2D Series Smart RFID Reader.
●
Tag list editing function
Up to 500 tag information can be registered in the tag list of the KW2D Series Smart RFID Reader. The tag list of the
KW2D Series Smart RFID Reader can be edited by using the master tag or host device. For details, refer to Chapter 5
"2.3 Edit the tag list" on page 5-17.
5
KW2D Series Smart RFID Reader Functions
IC Tag Standard
Non-contact IC Card and Tag Name
ISO/IEC 14443 Type A
MIFARE (NXP)
ISO/IEC18092 Type F
FeliCa (Sony)
ISO/IEC15693 Type V
Tag-it (Texas Instruments), I-CODE (NXP)
With the factory settings, the RFID reader detects RFID tags that support the three types of IC tag standards.
On the
RFID Reader Settings
tab of the KW RFID Configurator, in the
Tag Read Settings
, you can change
the RFID tags detected. For details, refer to Chapter 6 "IC Tag Standard" on page 6-12.
Tag Information
Description
Explanation
UID
Maximum 10 bytes of data Except for a complete match of UID, the verification result is a failure.
Name1
Maximum 18 bytes
Used to explain the UID. This information is not used by the KW2D
Series Smart RFID Reader.
Name2
Maximum 18 bytes
Authority
1 byte (1 to 255)
When an unregistered UID in the tag list or a disabled UID is read, the
authority is 0.
The buzzer and LED indicators can be enabled or disabled. The buzzer and LED indicators can also be
controlled from the host device. For details, refer to Chapter 5 "Operate the buzzer and LED" on page 5-16.
