Operating Instructions
STEP 6: Press the drill trigger switch until cable is completely cut.
Reverse mode on drill can be used to back off blade if necessary.
STEP 8: When finished, remove any dust or particles that may
have become attached to the blade.
STEP 1: Attach cable cutter drive shaft to drill as shown
(Figure 1). Tighten drill chuck securely.
STEP 4: Activate the drill trigger switch to open the moving
blade (Figure 4).
Figure 1
Figure 2
Figure 3
Figure 4
Figure 7
Figure 6
Tighten
handle
Loosen
handle
STEP 2: Loosen handle so torque arm extends freely (Figure 2).
STEP 3: Loop torque arm around drill handle and tighten
handle into locking collar to lock torque arm in place (Figure 3).
Do not operate tool without torque arm in place.
Figure 5
STEP 5: Place the cable to be cut onto the stationary blade and
close the moving blade around the cable. Feed the moving blade
by hand until the first gear teeth are engaged (Figure 5 and 6).
STEP 7: To cut several small cables continuously, cut first cable as
described above, then reverse blade until opening is sufficient to
feed the next cable through. Continue to alternate between forward
and reverse modes until all cables are cut (Figure 7).
