4
MSC-STAND18X
July 2018
Operation Instructions
To Support Load:
1. Change saddle height by adjusting the extension tube, then insert the support pin through
both
holes of the tube and collar (see Fig. 1). For a short distance, saddle height adjustment is available
by rotating the screw rod (see Fig. 2).
Fig. 1 Fig. 2
2. Check that support pin is securely seated across both tube and collar before loading. Ensure that
support pin is inserted completely so that it engages the collar.
3. Carefully position Stands so that load will be centered on Stand
’s saddle pad.
4. Carefully lower the vehicle onto all Stands simultaneously.
5. Check to ensure vehicle is properly balanced and stable before working on, around or under, if not,
raise the load again and reposition the Stands until a stable condition is achieved.
To Lower Load:
1. With suitable lift, raise vehicle clear of Stands.
2. Carefully release support pin and adjust extension tube to lowest position.
3. Carefully remove Stands, then lower vehicle with lift device.
WARNING
Be sure that all tools and personnel are clear before lowering load.
WARNING
USE ONLY on areas of the vehicle as specified by the vehicle manufacturer. USE
ONLY on vehicles whose support points are compatible with the saddle of Stand.
Incompatibility may result in structural damage to the vehicle and/or Stand.
Structural damage to either may result in sudden and unexpected loss of load
height!
