17
MSC-18K-X
May 2019
11. 12. 13.
MODE
Buttons
To select between the functions:
“WHEEL”, “AXLE
” & “
ALL”
14. BIAS
Button
To set the zero point of height in initialization.
15. START
Button
To start the running of the software.
16. SHIFT
Button
This button is for the running of the program.
17. ENTER
Button
This button serves confirming of instruction or entering sub menu.
18. ESC
Button
Serves to enter or exit from menu; or from sub menu to upper lever menu.
19. LCD SCREEN
Display the height readings of columns & information
20. WARNING Light
This light will go on when the EMERGENCY button is pressed.
21. CABLE Port
This port is used for communication cable connection.
22. BATTERY
Indicator
This indicator shows the output voltage of the batteries.
23. LED Light Socket
This socket provides the DC power for the LED light.
24. CHARGING Lamp
This is to indicate the batteries are in charging.
25. FINISHED
Lamp
This is to indicate the batteries are fully charged.
Note:
Before turning on again the Power Switch, please wait for 20 seconds.
In “Axle” mode, are always paired as 1# & 2#, 3# & 4#, 5# & 6# per each vehicle axle.
In “ALL” mode, all columns move together.
In “Wheel” mode, each column moves individually.
In case of emergency, push down the ‘EMERGENCY’ button to stop. If any motor does not stop, turn
off the battery switch on column’s right side to make an immediate cease.
