Supplied By www.heating spares.co Tel. 0161 620 6677
3
Henrad WH LXFF & FF -
User's
WH LX FF & FF
(
Natural Gas Models Only)
PI No. 87AP107
Minimum clearances
A clearance of 533mm (21") MUST be available at the front of the
boiler for servicing.
The minimum clearances given below MUST be complied with
in order to maintain the safe running of the boiler and to
facilitate servicing.
Above the boiler
100 mm
(4")
At each side of the boiler
5 mm
(
1/4
")
Underneath the boiler
100 mm
(4")
In front of the boiler
450 mm
(17
3 /4
")
Introduction
It is essential that the instructions in this booklet are
strictly followed, for safe and economic operation of
the boiler.
Gas Safety (Installation & Use) Regulations 1994,
amendments 1996, or the rules in force.
In your own interest, and that of safety, it is the law that this
boiler must be installed by a registered installer, in accordance
with all national and local regulations.
Electricity Supply
This appliance must be efficiently earthed.
Supply: 230 V ~ 50 Hz.
The fusing should be 3A.
Connection must be made in a way that allows complete
isolation of the electrical supply such as a double pole
switch having a 3mm (
1/8
") contact separation in both
poles, or a plug and socket, serving only the boiler and
system controls. The means of isolation must be
accessible to the user after installation.
Important notes
a.
This appliance must not be operated without the casing
correctly fitted and forming an adequate seal.
b.
If the boiler is installed in a compartment then the
compartment MUST NOT be used for storage purposes.
c.
The ventilation provided for the boiler during installation
MUST NOT be blocked, and a check should be made
periodically that the ventilation areas are free from any
obstruction.
d.
If it is known or suspected that a fault exists on the boiler
then it MUST NOT be used until the fault has been
corrected by a CORGI registered installer.
e.
Inflammable materials must not be placed in close
proximity to the appliance. Materials giving off flammable
vapours must not be stored in the same room as the
appliance.
f.
Under NO circumstances should any of the sealed
components on this appliance be used incorrectly or
tampered with.
CAUTION.
To avoid the possibility of injury during the installation, servicing or cleaning
of this appliance care should be taken when handling edges of sheet steel components
Standard
Deluxe
WH
30 FF .............................. G.C. No. 41 349 87
WH
40 FF .............................. G.C. No. 41 349 88
WH
50 FF .............................. G.C. No. 41 349 89
WH
60 FF .............................. G.C. No. 41 349 90
WH
70 FF .............................. G.C. No. 41 349 91
WH
80 FF .............................. G.C. No. 41 349 92
WH 100 FF ............................. G.C. No. 41 349 93
WH
LX 30 FF ................ G.C. No. 41 349 94
WH
LX 40 FF ................ G.C. No. 41 349 95
WH
LX 50 FF ................ G.C. No. 41 349 96
WH
LX 60 FF ................ G.C. No. 41 349 97
WH
LX 70 FF ................ G.C. No. 41 349 98
WH
LX 80 FF ................ G.C. No. 41 349 99