IDEAL 7000TLX, Руководство по сборке и эксплуатации

Страница: 11 / 17

11
TLX-7000
Aug 2021
OPERATION INSTRUCTIONS
To Raise Vehicle:
·
Place vehicle in PARK and set Parking Brake.
·
Use on hard level surfaces only, keeping area clear around vehicle.
·
Measure the width between chassis frame rails for correct Platform location.
·
Roll lift under vehicle with the Drive Gearbox, typically closest to front wheels.
·
Position lift Platforms under both the driver
’s & passenger’s side of the vehicle’s frame. If necessary,
adjust Platforms side-to-side for proper alignment to chassis frame.
Vehicles with pinch welds may require Platform Riser Bars for proper clearances to avoid
causing damage to vehicle or lift.
·
Insert Drill Adapter into drill and tighten.
·
Select which side of Tilt Lift & vehicle will be best to work from. (See NOTE Info. below)
The iDEAL 7000TLX is equipped with twin dual-action gear drives & dual independent
safety lock bars & safety pins. The twin dual-action gear drives & dual independent safety
lock bars allow for full operation from either side, using the ‘forward & reverse’ function of
the power drill.
For single direction drills, lift operation can still be easily utilized by using the side-specific
gearbox for ‘Up & Down’ lift operations, as indicated on the Gearbox decal plates.
·
Connect power to Drill, double checking drill
’s rotation, prior to inserting Adapter into Gearbox Socket.
Before raising vehicle, verify that there is enough overhead clearance for vehicle once
raised & tilted.
·
Raise lift until lift Platforms contact the chassis frame of the vehicle. If Platforms are not lining up
properly, lower lift slightly and readjust Platforms.
·
Once lift is reset and Platforms are properly adjusted, raise lift to desired height. Lifting slowly.
As you raise the vehicle, typically the front half of the vehicle will begin to drop as the rear
of vehicle raises.
·
Once lift is at desired height and one set of wheels are touching the ground, insert Safety Locking Pin
into one of the Safety Lock Bars.
Always Insert Safety Lock Pin, after vehicle has been raised to the desired height.
·
Position Jack Stand under raised side of the vehicle. Adjust the Pillar height to support a solid section
of vehicle chassis, followed by inserting pin into hole to lock Pillar into position. Ensure Jack Stand is
placed on solid surface able to support vehicle.