AutoStand_Plus_Manual_US-EN_2021-04
1-866-828-6737 idealwarehouse.com 2021-04-27
Gas Shock Removal/Installation Instructions
Step 1:
Post safety warning and barricade work area, to prevent unauthorized use of the area while service
work is being performed.
Step 3:
Locate the top channel nut and bolt assembly for the gas shock
(located under the top channel assembly). Using a 14mm (or
9/16”) deep socket and ratchet on the bolt head and a 14mm (or
9/16”) deep socket on the nut, loosen the assembly completely.
Remove nut and bolt (save for re-use).
Step 4:
Using a forklift (recommended) or 2 people (one on each side), lift
the top channel assembly off the lower tube assembly. Place the
top channel assembly in a safe location for re-use later.
Step 5:
Locate the lower nut and bolt assembly for the gas shock, (located
at center of the lower tube assembly). Using a 14mm (or 9/16”)
deep socket and ratchet on the bolt head and a 14mm (or 9/16”)
deep socket on the nut, loosen the assembly completely.
Remove nut and bolt assembly (save for re-use).
Note:
Do not over tighten.
Step 2:
Ensure the Stand is in a vertical upright position. Remove and store the locking pin. Allow the Stand to
rise to its maximum raised position (as high as the unit will go).
Down
UP
