Ideal Security SK642, Руководство пользователя и инструкция по установке

Страница: 10 / 33

HOME
specified memory location will automatically be dialed. Press the PROG button to
stop the dialing. The auto dialer must be connected to a land line in order for this function
to work. If not connected, then you will hear 4 short beeps.
12. TO TEST THE WIRELESS SENSOR TRANSMITTING RANGE
After selecting a location for the units, but before installing permanently, you
should test the signal range of all units. Press the HOME button on the left side of the
auto-dialer, wait 60 seconds at which time you will hear a beep. Then trigger the water
detectors by dipping the probe into a cup of water. The auto-dialer will receive a signal
and a chime will sound. If you do not hear a chime and the zone is not flashing on the
auto-dialer screen, the water detector may be out of range of the auto-dialer.
Repositioning either the sensor or auto-dialer should fix this problem. Press
HOME
button again to exit test mode.
OPERATION
1. TO ARM THE SYSTEM
a. Enter password followed by the ARM/DISARM button.
b. Three short beeps will sound and the ARM icon will show on the auto-dialer
screen.
c. You can also press the ARM button on the remote control unit (SK629 sold
separately) to ARM the auto dialer. (if learned)
d. Wait 60 seconds for a short beep. The auto-dialer is now set at ARM and ready to
receive signals.
e. When the system is armed (ARM), if you have installed and learned a door or
window detector and if a door or window is open the auto dialer will beep for 5
seconds and the screen with show “CLOSE PLEASE” and also indicate the zone
number. If the door or window is still not closed it will start dialing after 60
seconds.
2. ALARM
a. If the auto-dialer (in ARM mode) receives a signal from the water detector, the
screen will display
TRIGGER with the zone number 1. If the auto-dialer (in
ARM mode) receives a signal from any sensor, the screen will display
TRIGGER with the zone number. After the delay entry time it will sound a
SIREN for 30 seconds on, 30 seconds off and 30 seconds on, and will
automatically dial all the numbers stored, one by one, for
the CYCLE (amount of
times the numbers are dialed) you have chosen. The receiver of the phone call
will hear
one beep cycle for zones 1-7 and 8S , two beep cycles for 24hr zone
and four beep cycles for PANIC . The receiver of the call can then call a
neighbor, or take other appropriate action.
b. In ARM mode, if the auto-dialer is set to SIREN OFF , the numbers stored will be
dialed silently. No siren will be heard from the installed location. When the call is
answered you will hear the sequence of beeps and know which zone was triggered.
3. TO DISARM THE SYSTEM