IDEAL INDUSTRIES NaviTEK II, Руководство пользователя

Страница: 6 / 46

151810 Iss 1 NaviTEK II
Page 6 User Guide
Switching ON and OFF
To switch the tester ON, press and hold the Power button. Wait until the home screen is visible on the
display; the tester is ready for use.
To switch the tester OFF, press and hold the Power for approximately 1/2 second, a shutdown message is
displayed on the screen. The currently stored setup is saved. If the tester does not switch OFF within five
seconds, see
Master Reset .
Power Saving
Power saving preferences are selected from SETUP>SYSTEM>PREF. Auto off can be Disabled (tester
remains ON indefinitely), or set to switch the tester OFF after three, 10 or 30 minutes of inactivity. The
backlight can be set to Always On, or to dim to 50% brightness after three minutes of inactivity. Note that
when mains power is connected the display is always on full brightness and the tester remains ON
indefinitely.
Master Reset
In the unlikely event of a system lock-up which prevents the tester from being switched OFF, it may be
necessary to perform a master reset. This will not delete any stored data.
Remove the power module or battery pack to access a small aperture in the NaviTEK II (Fig 2).
Insert a paper clip into the reset hole and press the internal reset switch.
Fig 2
Replace the power module or battery pack.
www.vemco.pl