IDEAL INDUSTRIES NaviTEK II, Руководство пользователя

Страница: 21 / 46

NaviTEK II 151810 Iss 1
User Guide Page 21
Tone
Fig 27
NaviTEK II can act as a tone generator (Fig 27).
Together with a compatible tone probe, the route of
a cable can be traced. A choice of three tones can
be selected. To achieve the best result, the tone
may be played over one of eight pins relative to the
other seven, or over one of four pairs. The tone is
started and stopped with the F1 soft key which
displays as RUN or STOP accordingly.
Press the soft key SETUP (F3) to change the tone
and the pin, or pin pair, that the tone is played on.
Press the soft key APPLY (F2) for your changes to
take effect.
Auto test
NaviTEK II can be set up to run a predefined range of
tests when the yellow Autotest button on the handset
is pressed. The range includes Wiremap, Ping4,
Ping6,
TRoute4, TRoute6 and Netscan.
The range of tests is set from
SETUP>TESTS>AUTOTEST by ticking the check
boxes next to your choice, Fig 28. Press the soft key
APPLY (F2) for your changes to take effect.
When an Autotest is run, Fig 29, the display shows a
list of selected tests and the status of each. After the
Autotest is complete, or has been stopped, each
individual test can be selected and its detailed results
displayed.
In Cable mode, Autotest is limited to Wiremap.
Fig 28
Fig 29
www.vemco.pl