User Guide
5
USER
1.5 LOSS OF SYSTEM WATER PRESSURE
The gauge (G) indicates the central heating system pressure.
If the pressure is seen to fall below the original installation
pressure of 1-2 bar over a period of time then a water leak
may be indicated. In this event conduct the re-pressurising
procedure as follows:
Re-pressurise via the filling loop to 1 bar (if unsure contact
your installer). Turn off the tap on the filling loop and press the
“RESTART” button (E) to restart the boiler.
If unable to do so or if the pressure continues to drop after
filling a Gas Safe Registered Engineer should be consulted.
Note.
The boiler will not operate if pressure has reduced to
less than 0.3 bar under this condition.
FOR ANY QUERIES PLEASE RING THE IDEAL
CONSUMER HELPLINE : 01482 498660
BOILER RESTART PROCEDURE - To restart boiler
press the restart button (E)
1.6 POINTS FOR THE BOILER USER
In line with our current warranty policy we would ask that you
check through the following guide to identify any problems
external to the boiler prior to requesting a service engineers
visit. Should the problem be found to be other than with the
appliance we reserve the right to levy a charge for the visit, or
for any pre-arranged visit where access is not gained by the
engineer.
Preventative solutions
During cold weather, set the central heating temperature knob
(A) to maximum (must return to original setting once cold spell
is over).
Place the heating on continuous and turn the room thermostat
down to 15ºC overnight or when unoccupied. (Return to normal
after cold spell).
1.4 GENERAL INFORMATION
BOILER PUMP
The boiler pump will operate briefly as a self-check once every
24 hours, regardless of system demand.
MINIMUM CLEARANCES
Clearance of 165mm above, 100mm below, 2.5mm at the sides
and 450mm at the front of the boiler casing must be allowed for
servicing.
Bottom Clearance
Bottom clearance after installation can be reduced to 5mm.
This must be obtained with an easily removable panel, to
enable the system pressure gauge to be visible and to provide
the 100mm clearance required for servicing.
ESCAPE OF GAS
Should a gas leak or fault be suspected contact the National
Gas Emergency Service without delay.
Telephone 0800 111 999
.
Ensure that;
- All naked flames are extinguished
- Do not operate electrical switches
- Open all windows and doors
CLEANING
For normal cleaning simply dust with a dry cloth. To remove
stubborn marks and stains, wipe with a damp cloth and finish off
with a dry cloth.
DO NOT use abrasive cleaning materials.
MAINTENANCE
The appliance should be serviced at least once a year by a
Gas Safe Registered Engineer.
SCAN
for video
