To Shut Down the Boiler
1. For short periods
Set the boiler on/off switch (1) to OFF.
2. For longer periods
Set the boiler on/off switch (1) to OFF. Switch the electricity
supply to OFF. For longer periods the entire system should
be drained.
To Relight the Boiler
Refill the system if it has been drained, taking care to ensure
no air is in the boiler or system.
Repeat the procedure detailed in 'To light the boiler'.
F r o s t P r o t e c t i o n
If frost is likely and dependant on the system controls, which
may incorporate suitable safety features, leave the boiler
thermostat at a reduced temperature setting. Ensure external
controls allow the boiler to operate if necessary. Note that this
may not protect remote parts of the system, in which case a
separate frost thermostat should be fitted or the system
drained and the boiler shut down, as for Long Periods.
B o i l e r O v e r h e a t T h e r m o s t a t
Boiler overheating is detected by the overheat thermostat
connected to the boiler control module. If the boiler has
overheated, allow it to cool then, press the safety thermostat
reset button, under the screw top cap (7), and the burner will
relight. If the fault recurs, turn off the boiler and consult a
recognised installer (CORGI registered for gas-fired boilers.)
Escape of Gas
Should a gas leak or fault be suspected contact your local gas
supplier without delay.
Do NOT search for gas leaks with a naked flame.
C l e a n i n g
For normal cleaning simply dust with a dry cloth.
To remove stubborn marks and stains use a damp cloth and
mild detergent.
DO NOT use abrasive cleaning materials.
Ideal Boilers
, P.O. Box 103, National Ave, Kingston upon Hull, HU5
4JN. Telephone: 01482 492 251 Fax: 01482 448 858. Registration
No. London 322 137.
November 2007
UIN 203622 A01
Ideal Stelrad Group
pursues a policy of continuing improvement
in the design and performance of its products. The right is
therefore reserved to vary specification without notice.
Ideal Commercial/Technical Helpline: 01482 498 376
www.idealboilers.com
