Ideal Boilers Atlantic 24, Инструкция по установке и обслуживанию, Страница: 45 / 80

45
Installation and Servicing
SECTION 3 - SERVICING
screwdriver slot
3.15 DIVERTER VALVE ACTUATOR REPLACEMENT
1. Refer to Section 3.8.
Note: Ensure condensate trap is fully drained
before removal.
2. Pull off the rubber pipe at the SIPHON.
3. Disconnect the condensate drain pipe.
4. Turn the siphon clockwise to disengage and
lift to remove.
5. Reassemble in reverse order.
6. When reassembling ensure the trap is full of
water.
7. Check operation of the boiler. Refer to
Sections 2.24 & 2.25.
3.16 CONDENSATE TRAP/SIPHON REPLACEMENT
Diverter Valve Motor To remove the motor:
1. Refer to Section 3.8.
2. Remove the condensate trap/siphon. Refer to
Section 3.16.
3. Remove the wiring connector by inserting a
terminal screwdriver to release the latch, then
withdraw the connector.
4. Place a flat bladed screwdriver in the actuator
slot provided and ease out the actuator.
5. Before replacing the diverter valve actuator
proceed as follows:
a. Ensure that the switched live to the boiler is
off and that all DHW taps are shut and that
pre-heat is switched off.
b. Hold the mode knob in the restart position
for more than 10 secs.
c. The display will display “
U
” and the actuator
will move into the mid-position.
d. The divertor valve will initially drive all the
way out, this may cause the spindle to
become detached from the body. If this
occurs simply screw back into the body so
the cycle can continue driving fully in before
going to mid-position.
e. Replace the actuator into the boiler.
6. Fit the new motor ensuring the arm is correctly
engaged in the metal fork and re-assemble in
reverse order ensuring the condensate trap/
siphon is refilled with water.
7. Check the operation of the boiler. Refer to
Sections 2.24 & 2.25.
Note. All spares will be delivered in mid-position
therefore ignore point 5 and proceed to point 6.





SER
VICING