inSTALLATion MoDE SELECTion
1
Press and release
programming button
to select installation mode.
2
Press and hold
programming button
until LED turns solid GREEN
to register selection.
!
After registration, follow Factory Reset Procedure to
change installation mode and restart this procedure.
LED fl ashes (1X) once = DATA MODE
LED fl ashes (2X) twice = STANDARD HARDWIRE MODE
MoDULE ProgrAMMing ProCEDUrE
8
Module Programming
Procedure completed.
1
Push start button twice [2x] to
ON position.
ENGINE
START
STOP
Æ
x2
5
Push start button twice [2x] to
ON position.
ENGINE
START
STOP
Æ
x2
7
Push start button once [1x] to
OFF position.
ENGINE
START
STOP
Æ
x1
3
Push start button once [1x] to
OFF position.
ENGINE
START
STOP
Æ
x1
6
Wait, LED will turn solid GREEN
for 2 seconds.
2
Wait, if LED turns solid GREEN
for 2 seconds, proceed to step 7.
If LED fl ashes GREEN rapidly,
proceed to step 3.
4
Wait, LED will turn solid RED.
(This may take up to 5 minutes.)
Page 8 of 9
ADS-AL(DL)-TL7-EN
20141104
install guide
guides Français disponibles au www.idatalink.com
www.idatalink.com/support
automotive data solutions inc. © 2014
ALL IN ONE
Lexus/ToyoTa
Doc. No.: ##17111##
