Take the grey thermal pad
G
or
H
,
remove the protective film on both
sides and put it on the installation
surface the thermal pad adheres
independently.
Take the blue thermal pad
E
or
F
, remove
the protective film on both sides and apply
it to the M.2 SSD. The thermal pad adheres
independently.
Depending on which housing you are using, fasten the
profile plate
C
or
D
with the remaining large black screws.
Connect the PCIe card and your ARGB controller
using the 3-pin ARGB cable
I
.
Place the heat sink
B
in front of you with the backside facing
upwards. Place the PCIe card with the long side against the
edge of the heat sink and then put it on. Fasten the heatsink
with the 4 small black screws
L
at all four corners.
Remove the spacer
J
from the screw set and
place it on the semicircular notch of your
M.2 SSD. Carefully insert your M.2 SSD
into the M.2 socket with the connection side
at an angle of about 30°. Make sure that
the tongue (SSD) and groove (socket) are
opposite each other.
Push the M.2 SSD down and fix
it to the rear end of the M.2 SSD
with the silver pan head screw
K
from below.
Manual IB-PCI224M2-ARGB
