ULTRA ARM INSTALLATION - rev 04/22/14 pjm
Page 3 of 4
ATTACH VESA TO UL 500
Mount the
VESA assembly
to the friction
mount by sliding
the connecter into the UL500
pivot block. Using the 5/32” hex
key, secure fl at head screw back
into place.
ATTACH VESA TO MONITOR
Attach the
VESA plate to
your monitor
using the four
4mm screws in
the hardware bag.
ADJUST TILT HANDLES
Use the handles to adjust
the tilt of the monitor.
IF USING UL500
ADJUST BALL VESA
TENSION & HEIGHT
Use the slider knob to
loosen the slider to adjust
the height of the monitor
on the Paralink.
Adjust the pivot tension
of the ball by gently and
evenly tightening or
loosening the four screws
on the back of the ball
VESA.
Slider Knob
Pivot tension
adjustment
screws
IF USING UL550
ADJUST
PARALINK TILT
Adjust monitor to desired
position with ball VESA.
Tilt your monitor 50°
in any direction. Adjust
your monitor between
portrait and landscape
by rotating ball VESA.
Adjust monitor depth
by moving the paralink
forward or back then
t i g h t i n g t h e d e p t h
adjustment knob.
Depth
Adjustment
Knob
ATTACH PARALINK TO ULTRA ARM
Attach to Paralink to Ultra arm
using 3/8 bolt assembly and
1” bearing assembly provided.
Insert bolt assembly up through
arm. Place 1” bearing assembly
over bolt on other side of arm.
Place Paralink over bolt and
bearing and turn bolt until
Paralink is secure and smoothly
turns against the bearing.
1” bearing
assembly
3/8 bolt
assembly
Beauty
cap
Paralink
Ultra arm
ATTACH TO MONITOR
Attach your monitor to the VESA
plate user the four 4mm screws in
the hardware bag.
