Adjust the tilt of your flat panel
monitor using the handles on the
right side of the friction mount.
ADJUST TILT
To tighten your
210 arm, first
remove the
plastic beauty
cap. Then take
7/32” hex key
wrench provided and tighten the bolt
that connects the arms.
TIGHTEN JOINTS
You can make your keyboard
flip-up fold down by taking out
the stop pin as shown.
KEYBOARD FLIP
Included hardware:
• 1/8” hex key wrench
• 5/32” hex key wrench
• 5mm hex key wrench
• 7/32” hex key wrench
• 4 wood screws
• 4 - 4mm screws with phillips drive
• VESA plate(s)
Install the keyboard using
the five 10/24 stainless
screws supplied.
KEYBOARD
CORD MANAGEMENT
Turn the arm assembly upside down and lay on a flat
surface. Take all the cables you wish to install and lay flat
beside the arm assembly. Using nylon wire ties or electricians
tape, make a harness out of the cabling. Make sure to form it in
such a way as to fit the cable cutout.
Remove the 4 screws on either side
of the cable channel, place your cords
in the channel and press the plastic
cover in over the cords. Replace the 4
screws.
