ULTRA 180 ARM INSTALLATION - rev 04/09/14 pjm
Page 2 of 4
ATTACH WALL PLATE TO WALL
Locate the stud and mark the top hole,
drill 11/64 pilot hole and insert #14
screw and tighten slightly. Using a
level, mark the lower hole and drill pilot
hole, insert #14 screw and, with the
unit level, tighten both screws.
NOTE: ICW supplies #14 wood screws. If
installing onto metal studs, you will need to
replace with proper metal stud fasteners.
W2
W3
IF MOUNTING TO A WALL
IF MOUNTING TO A POLE
IF USING EV65
ATTACH VESA TO MONITOR
Attach the
monitor mount
assembly to
the back of
your monitor,
using the
4mm screws
provided.
ATTACH VESA TO EV65 JOINT
Socket
cap screw
VESA
plate
Insert stubs on VESA plate into
holes in the Ergovision joint
assembly. Insert 5/16 x 3/4
socket cap screws provided in
both sides and tighten. Use the
handle under mount
to loosen tilt friction
and adjust monitor
tilt.
ULTRA 180 ARM INSTALLATION
ATTACH POLE CLAMP TO POLE
Using the 1/4” hex key,
separate the two halves of
pole mount as shown, place
around pole at the desired
height and reassemble.
