Wall Mount
Desk Mount
Pole Mount
UL90 Installation Instructions
Locate the stud in the wall you are mounting to and mark the top hole.
Drill 11/64 pilot hole and insert the provided #14 wood screw, tight-
ening slightly. Using a level, mark the lower hole and drill pilot hole,
insert the last #14 screw and, with the unit level, tighten both screws.
Note: #14 wood screws are supplied; if installing into metal studs
you will need to use proper metal stud fasteners.
If your monitor is over 17", the mount may be more effective if
mounted upside down.
Screw stud into desk mount.
Drill a 3/8 hole through the horizontal surface you intend to mount
to and push the 3/8 stud on the desk mount through the hole. Slip the
large mounting washer over the stud from underneath, add the 3/8
split-washer, and secure in place with the 3/8 nylock.
Nylock
Large washer
Desk
Using the 1/4" hex key, separate the two halves of your pole mount as
shown, place around pole at the desired height and reassemble.
ul90.indd rev. 2/25/09 sk
3/8 Split-
washer
