ICWUSA.com, Inc.
If you have any questions, please call 1-800-558-4435
ELITE DOUBLE ARM
ELITE DOUBLE ARM INSTRUCTIONS - rev 11/01/2013 mf
page 1
DANGER!
1. Do not attempt to adjust your Elite arm until
everything you intend to mount to the arm is
mounted.
2. Arm must be completely horizontal (extended)
before adjusting the arm’s tension. Failure to do
so will damage the arm and void the warranty.
3. Never loosen or remove any of the shoulder bolts. Doing so
will cause the arm to immediately come apart with tremendous
force, and could cause serious injury.
4. If equipment requiring AC power is mounted to this unit, have a
certifi ed electrician inspect the installation.
5. Failure to install this unit according to these instructions will void
all ICW warranties. If installed incorrectly, ICW is not liable for any
damage or injury caused by the unit.
6. Do not use power tools to adjust arm tension. MUST be adjusted
by hand.
The Elite arm contains high
pr essur e gas springs. T he
following cautions MUST be
observed to avoid serious injury.
ATTACH WALL
PLATE TO WALL
Locate stud and mark top
hole, drill 11/64 pilot hole
and insert #14 screw and
tighten slightly. Using a
level, mark lower hole
and drill pilot hole, insert
#14 screw and, with
unit level, tighten both
screws. ICW supplies
#14 wood screws. If
installing onto metal
studs, you will need
to replace with proper
metal stud fasteners.
ATTACH TO DESK
Drill a 3/8 hole through the horizontal
surface you intend to mount to. Screw
the 3/8 stud into your desk mount
as shown, the stud is found in your
hardware bag.
Push the 3/8 stud on desk mount
through the hole in the desk and slip
the large mounting washer over the
stud from underneath and secure in
place with the 3/8 nylock nut.
Detach the pole mount from arm using the provided
5mm hex key. Separate the two sections of the
pole mount using the provided 5/32 hex key. Place
around the pole you are mounting to and fi rmly
reassemble the pole mount.
ATTACH TO POLE
