TO ASSEMBLE
CAUTION:
Do not plug the product into an electrical outlet until it is fully
assembled.
1.
Before using the product for the first time, disassemble and wash as follows:
a.
Remove the Blade Assembly from the Jar by turning the Blade
Assembly counterclockwise.
b.
Remove the Gasket from the Blade Assembly.
c.
Wash all parts except the Motor Housing and Power Cord in warm,
soapy water and then rinse and dry thoroughly
.
WARNING:
Do not immerse the Motor Housing or Power Cord in water or
other liquids.
Do not use abrasive cleaners to clean any part of the product.
d.
Reassemble by replacing the Gasket into the Blade Assembly and
attaching the Blade Assembly onto the top of the Jar. Securely
tighten by turning clockwise.
e.
When inserting the Gasket into the groove, press the Gasket firmly
around all sies and test it by turning the Blade Assembly upside down
to make sure the Gasket is not loose or does not fall out. There will
be a small bump underneath the Gasket where the safety interlock
mechanism protrudes; it is normal.
2.
Place the Motor Housing on a flat, level, stable surface. To attach the Cup
Assembly (the Cup and the Blade Assembly securely attached together), align
the
symbol on the bottom edge of the Blade Assembly with the mark on
the Base and turn clockwise until it is firmly in place, aligned with the
symbol.
CAUTION
:
Handle Blades carefully, as they are sharp. Do not use
anything sharp to remove Gasket.
