8
ENGLISH
EN
4. Mount the suspension block using two threaded
bolts M10x25 mm
5. Attach the charging station to the pole by using
two threaded bolts M10x25 mm
6.
Attach the ground wire to the pole by using
M4x12 mm screws and one M4 circuit ring
7. Run the ground cable through the concrete
base and the pedestal to the charging station
Fig. 1: Mounting cable cover
8. Attach the cover plate to the pole using the anti-
theft bolt M8x16 mm (see Fig. 1)
9. Fill the hole and pave the area
10. Cover the area afterwards with a clean trim
(e.g. tiles)
Attaching the suspension block
1.
Insert appropriate wall plugs into the four holes
2.
Attach the suspension block on the lower two
holes with two screws on the wall
Preparation of the charging station
Never let the front cover hang on the wiring of the
LEDs and the display.
NOTICE
The white front cover of the charging station must
be removed before installing. Proceed as follows:
The front cover is firmly attached to the charging
unit and is secured with two screws at the top and
bottom.
1.
Place the device on its back
2.
Loosen the screws on the bottom with an Allen
key
3.
Loosen with a Torx M5 (T25) the two screws on
the (side of the) rear housing
4. Keep the screws in a safe place; they will be
required later
5.
Lift the front cover from the bottom upwards
6.
Loosen the wiring of the LED and optional on
the display (
13
on the left of the cover)
7.
Now take off the front cover
Mounting the charging station
Fig. 2: Attachment to the wall
1.
Place the rear cover vertically from above onto
the previously mounted suspension block
2.
Attach the rear spoiler at the top with two screws
(diameter: at most 8 mm) at the designated lo
-
cation (see Fig. 2)
3.4 Electrical installation
Read and follow all safety instructions in this
manual!
!
CAUTION!
The electrical system must be disconnected from
the power supply during assembly and mainte
-
nance work!
!
DANGER!
1.
Slide the power cable through the hole in the
gland (
7
on the left of the cover)
2.
Pull the power cord about 150 mm wide into
the housing. The power cord should be long
enough that it can be drawn from the ground or
Installation of the charging station
