ICU Medical LifeCare PCA, Техническое и сервисное руководство, Страница: 123 / 148

7.3 REPLACEMENT PROCEDURES
Technical Service Manual 7 - 31 LifeCare PCA
7.3.8.16
SPLASH SHIELD REPLACEMENT
The recommended tool for this procedure is an X-acto knife.
The replacement part for this procedure is:
Shield, Splash
To replace the splash shield, see
Figure 7-6
, and proceed as follows:
1. Disconnect the infuser from AC power.
2. Separate the front and rear enclosures as described in Section 7.2.2 .
3. Using the X-acto knife, remove the splash shield from the front enclosure.
4. Remove the protective backing from the replacement splash shield (two places)
to expose the adhesive and install the shield into the front enclosure.
5. Reassemble the infuser in the exact reverse order of disassembly.
To verify successful replacement of the splash shield, perform the PVT in
Section 5.6
.
7.3.9
REAR ENCLOSURE ASSEMBLY COMPONENT
REPLACEMENT
Rear enclosure assembly component replacement includes the replacement
of the following:
To replace the rear enclosure assembly components, see
Figure 7-12
and
Figure 7-13
,
and proceed as detailed in the following sections.
Note: Verify all connectors are fully seated before the front and rear enclosures
are closed and fastened.
- Fuses
- Pole clamp assembly
- Velcro strap and retainer plate
- Power supply PWA
- Pawl/ratchet assembly
- Rear enclosure harness assembly
- Equipotential post
- Pole clamp nut plate
- Left/right ground straps
- Interface panel ground strap
- Battery pad
- I/O PWA
- Patient pendant jack assembly