WIEGAND CONNECTION
When using the standard Wiegand Interface to the
access controller or reader expander two wiring methods
can be used. Dual LED operation allows the signalling of
both LED's independently using the LED control lines and
is ideal to show the status of alarm or other integrated
signals.
Figure 1 – Dual LED Connection
Single LED allows a single LED line to control both LED
colours.
Figure 2 – Single LED Connection
AUX BUTTON INPUT
Button input wiring configuration is shown in Figure 3. For
programming options refer to the Protégé System Manual
or the access controller manual for the system that the
Proximity Reader is connected.
Figure 3 - Button Input Wiring
Connect a normally open button or switch as shown in
Figure 3 and complete the programming within the Protégé
Integrated System for the functionality required.
External Button Input Mode and single LED
operation must be enabled when using this
wiring configuration.
PROGRAMMING
INSTALLER PROGRAMMING
By default the ICT Proximity Reader is factory configured to
send data in 26 Bit Wiegand Format, it will read all card
formats and operate in the dual LED line mode. This
configuration can be changed to suit system operating
requirements.
The programming card can only be presented
within the first 2 minutes from when the card
reader powers up.
Entering Program Mode
To program the Card Reader badge the programming
card once, the Card Reader will beep to indicate the card
has been read and then beep twice and illuminate the
RED LED to indicate programming mode has been
entered.
Address Selection
To select an address to program the programming card is
presented to the card reader the number of times
matching the address number.
Address
Programming Option
1 Card
Reading
Format
2 Data
Output
Format
3 LED
Configuration
4
Intelligent Tamper Mode
5
Auxiliary Button Input Mode
6 Operating
Mode
7
Add Standalone Master Card
8
RS485 Address
9
Door Pre-Alarm Time
10
Door Left Open Time
11 Version
Information
12 Default
15
Client Code Configuration
For example to program address three (LED
Configuration) the programming card will be presented to
the card reader three times.
The card reader will then respond by beeping twice and
flashing the RED LED to indicate data entry mode has
been entered and that the user should present the card
the required number of times to set the desired option.
Entering an address value that does not
exist will result in the reader timing out and
a long Beep tone being generated.
Data Programming
To program a data value in the selected address location
the same method as the address programming is used.
Present the Programming Card to the reader the number
of times matching the data value or option for the
selected address. The card reader will then respond by
beeping twice indicating the data was programmed
correctly and return to the address selection mode. An
invalid entry will result in a long tone being generated.
The data can be entered again or allow the Nano Prox to
timeout to select another address.