Tunnel Master® wbc Installation Guide
Page 51
Entrance Keypad DIP Switch Settings
The following picture and table shows the Entrance Keypad DIP switch and the various settings that may
be used.
NOTE:
The OFF position is toward the word OPEN or CONFIG on the circuit board.
The following picture shows the DIP Switch on the Keypad cover.
Switch
Setting
Default
Function
1
OFF
Address setting
1, 2 OFF
= Address 5
1 OFF, 2 ON
= Address 6
2
OFF
Address setting
1 ON, 2 OFF
= Address 7
1, 2 ON
= Address 8
3
OFF
Baud Rate
OFF = 9600
ON = 38,400
4
OFF
Test Mode
Second Entrance Keypad Mounting
The following instructions provide proper installation of the optional second entrance keypad.
The second entrance keypad should be mounted securely to the wall of the car wash, directly
next to the first entrance keypad in the entrance to the tunnel.
The keypad is a Type 3 enclosure, which means it is a watertight enclosure, but should not be
mounted where it is constantly inundated with water.
The keypad should be mounted away from corrosive chemicals.
Figure 45. Keypad Reset and DIP Switch
Table 19. Entrance Keypad DIP Switch Settings
