5. Setting up the device
11
Menu group level
Menu level
5.4. Extended parameterisation (Professional operation level)
5.4.1. Signal input parameters
Menu level
Parameterisation level
Type of temperature metering,
Default:
The temperature can be displayed in
°
C or in
°
F. Confirm the selection with
[P]
and the display
switches back to menu level.
Setting the decimal point,
:
Default:
The decimal point on the display and the physical unit can be changed with
[▲] [▼]
. If e.g.
temperature measurement in
°
C is selected, then choose between 0
°
C and 0.0
°
C in the
parameterisation level. Confirm with
[P]
, the display then switches back to the menu level
again.
Setting the measuring range start / offset value,
:
Default:
The value for the sensor calibration is selectable from the smallest to the highest digit with
[▲][▼]
and confirmed with
[P]
. After the last digit the display switches back to the menu level
again. The value calibration for a temperature measurement in
°
C can be adjusted between -
20.0 and +20.0 and in
°
F between -36.0 and +36.0. If the type of the measurement is changed
later, then the value is rounded.
Device undercut,
Default:
With this function the device undercut (
) can be defined on a definite value. Exception is
input type
4-20 mA
, it already shows undercut at a signal <1 mA, so a sensor failure is marked.
