ICS 701A, Руководство оператора

Страница: 19 / 32

701-A SERIES OPERATOR’S MANUAL
© 2015 ICS, Blount International Inc. Specifi cations are subject to change without notice. REV02292016 F/N 573498
19
SYSTEM CLEAN-UP
1. Run saw, with water on, for 15 seconds out of cut to fl ush slurry and debris
from chain, bar and drive sprocket.
2. Wash concrete slurry from saw body.
3. Remove bar and chain. Flush out chain tensioner assembly location with
high water pressure and lube with grease.
4. Clean all air fi ttings on saw and compressor.
5. When done cleaning saw, spray entire saw body, chain, bar, and drive
sprocket with a lightweight penetrating oil. This will minimize rust and
reduce slurry build up on saw assembly.
OPERATION