![background image](http://html2.mh-extra.com/html/ics/660gc/660gc_operators-manual_3534845013.webp)
© 2012 ICS, Blount International Inc. Specifications are subject to change without notice. REV020212 F/N 549305
660GC OPERATOR’S MANUAL
13
COLD ENGINE STARTING PROCEDURE
1. Toggle the ignition switch to the "ON" position and pull the choke lever
out.
2. Lock the throttle in the start position by depressing the trigger
(A) and trigger interlock (B) at the same time.
3. Depress and hold throttle lock button (C) while releasing the trigger
and trigger interlock in succession.
4. Open the water valve 1/4 turn.
5. Press decompression valve (D).
6. Place the saw on stable ground making sure the chain
is free of any obstructions.
7. Place foot on the base of the rear handle, and place one hand on front
handle.
8. With opposite hand, slowly pull starter handle until the
starter pawls engage.
9. Pull the starter cord (
hard, fast, short pulls
)
until engine initially fires or "pops"
.
Could be as many as 10-15 pulls.
10.
Push the choke lever in.
11. Pull the starter cord until engine starts. Could be as many as 5 to 7
pulls.
12. When the engine starts, allow the engine to idle. Pull on the throttle
trigger several times to help warm up the engine.
13. Open the water valve completely.
CAUTION
STARTING AND STOPPING THE SAW
Never start the saw without the guidebar, diamond chain and side
cover properly assembled. The clutch may come loose and cause
personal injury.
Always move the saw at least 10 feet (3 m) away from the fueling
area before starting.
Place the saw on clear ground. Ensure that secure footing is
established and diamond chain is not contacting any objects.
IMPORTANT
WARNING
Warm Engine Starting Procedure
1. Use the same procedure as starting cold engine, but
DO NOT pull choke lever out
. If choke is used, the
carburetor will flood with gas.
2. If the engine does not start in 3 hard, fast pulls with the throttle locked, open the throttle fully and pull the
starter cord 3 more times.
Note: To hold the trigger fully open it may be necessary to insert right foot into rear handle opening and
twist.
Figure 1: a-Trigger, b-trigger
interlock, c-throttle lock
C
B
A
Figure 2: Decompression valve
D
OPERATION
Содержание 660GC
Страница 2: ......