ICS Advent PCI-ICOM485/4, Руководство по эксплуатации продукта

Страница: 12 / 31

Manual Number: 00650-148-1 Page 4
PCI-ICOM485/4 Manual
To install the card:
1. Turn OFF computer power.
2. Remove the computer cover.
3. Install jumpers from either the
Option Selection section of this manual or the suggestions
of our SETUP.EXE software program.
4. Install the card in an available PCI-bus slot.
5. Inspect for proper fit of the card and tighten screws.
Make sure that the card mounting
bracket is properly screwed into place and that there is a positive chassis ground.
6. Replace the computer cover and turn the computer ON.
7. Enter the CMOS setup program of your system and verify that the PCI plug-and-play option
is set appropriately for your system. Systems running Windows95 (or any other PNP-
compliant Operating System) should set the CMOS option to OS. Systems running under
DOS, WindowsNT 3.51, Windows 3.1, or any other non-PNP-compliant Operating System
should set the PNP CMOS option to BIOS or Motherboard. Save the option and continue
booting the system.
If you are using Windows95, your operating system should detect the new hardware and prompt
you for the installation disk. Insert the provided diskette into the A drive and allow the operating
system to look for the files that it wants.
The base address assigned by BIOS or the operating system can change each time new hardware is
installed into or removed from the computer. Please re-check PCIFind or Device Manager if the
hardware configuration is changed,
PCI cards are assigned resources by the system. To determine the resource assigned, run PCIFind
(DOS/Win 3.1), PCINT(Win95/98/NT), or look in the operating systems list of Detected Devices.
In Win95/98/NT, this is the Device Manager of the system applet, found in the control panel. See
the Tools diskette for more information on PCIFind and PCINT.