Option 2: USB Extender Direct Surface Mounting
(using your own hardware)
The bottom of the Ranger 2312 enclosure features four pre-drilled holes for optional direct surface
mounting. Using the stencil below, along with your own hardware you can directly mount your USB Extender
on a surface.
Distance between the enclosure mounting holes:
42.00 x 62.53mm
1. Mark the center point of each of the four holes on your mounting surface either by directly measuring or
using a print out of the stencil below.
2. Hardware recommendation: M2.5 locking washers and M2.5 screws (4 of each per extender) noting
screw length will depend upon thickness of mounting surface.
3. Drill through each of the four-hole markings on the mounting surface using a 3.70mm (0.1457”) drill bit.
4. Align the bottom enclosure holes to the newly drilled out holes on the mounting surface.
5. Place a locking washer on each of the four screws and using a screwdriver, fasten the extender into place.
To ensure the stencil below prints to scale be sure to set the page scaling setting to “none”.
Direct Surface Mounting Measurement Stencil
Option 3: Cable-Tie Mounting
The bottom of the Ranger 2312 enclosure also features four convenient slots for
cable mounting. Simply thread a cable tie, (also called tie-wrap or zip tie), into the
mounting slot and through the cable tie head, and secure it to a pole or other
surface by pulling it tight. Cable ties are not included with this system due to
varying lengths dependent upon the application.
note
10
