Installing the Ranger 2304 System
Requirements
To complete the installation, you will also require the following items that are not included with the product:
•
USB compatible computer (host computer) with a USB compliant operating system
•
USB compatible device(s)
•
Cat 5e Unshielded Twisted Pair
(UTP) cable with two RJ45 connectors (if using surface cabling),
OR, Cat 5e cabling with two information outlets and two Cat 5e patch cords with RJ45 connectors
(if using premise cabling)
Preparing Your Site
Before you can install the Ranger 2304, you need to prepare your site:
1.
Place the computer where desired and set it up.
2.
Ensure that where you want to locate the USB device(s) is within 100m (cable-length) of the
computer. If not, adjust the location of the devices and/or computer accordingly.
3.
If you are using surface cabling, install the Cat 5e cabling as desired and terminate it with the
appropriate RJ45 ends.
If you are using premise cabling, ensure Cat 5e cabling is installed between the two locations and if
necessary patched together. Cat 5e information outlets should be located near the computer and
the USB device(s), and the total length, including patch cords must be less than 100m.
Cable installation is important, particularly if high throughput applications are used. When installing, ensure the cable is
installed away from or isolated from potential sources of interference such as electrical wiring, flourescent lighting, etc.
When terminating cables, ensure the matching RJ45 connector is used for the cable type. For example, if Cat 6 cable is
used, then Cat 6 compatible RJ45 connectors must be used. If this care is not taken, the benefits of higher grade
cabling may not be realized.
Computer
USB Devices
LEX
Up to 100m between extenders over Cat 5e (or better)
REX
note
Cat 5e Link Cable
USB cable
6
