To turn the
on, press and hold
.
To turn the receiver off, press and hold .
receiver
Turning On / Off
1. P
Register
.
2. Press the
Call
button of the Outdoor station, then using a
small object, hold the
Register
key on the back of the Outdoor
station until the LED light blinks. When a prompt tone is heard,
the Outdoor station has been registered to the Receiver
successfully.
If a double
prompt
tone is heard, the registration was not
successful. Turn the Receiver off. Remove the batteries from the
Outdoor Station for 30 seconds. Turn the Receiver on again and
re-install the Outdoor Station’s batteries. Repeat steps 1 and 2
again to register the Outdoor Station.
ress beneath
Menu
on the Receiver, then select the
Register a New Outdoor Station
11
Call button
Register
key
16
Note:
The Outdoor Station and Receiver are already registered
together as supplied in as a set. These instructions are for
adding up to 3 more Outdoor Stations.
LEDs will light the caller when the ambient light becomes too low.
Light Sensor
if you press and hold for 3 seconds, the communication
between the Receiver and the Outdoor Station will discontinue for
5 minutes. Then, the connection will resume and operate as
normal.
Do Not Disturb Mode
Receiver Display
The figure shows the regular display that appears when the
receiver is activated from standby mode.
A Battery charge condition of the receiver
B During a call
C Low battery condition of the outdoor station (if batteries are
inserted)
D Signal strength of the outdoor station
E Zooming
F Reject the call
G The plug icon appears when the outdoor station is powered
with 12 VDC instead of batteries.
H Number of the outdoor station(1#)
A
F
E
G
B
C
D
X
H
Operations
Shaker jack
