Mobile DVR Installation Instruction Guide
3
Setup and Debug
After installation, please following processes listed below to check the device installation and electric
connection and then begin system debug. The whole system needs to pass the all test and debug before it
begins trial run.
Before connect to the power socket. Please check:
z
The DVR power is within the normal threshold.
z
The signal connection is OK.
Then you can boot up the device and begin debug.
z
Check the power button, mobile DVR indication light is OK.
z
GPS status and WiFi status are both OK.
z
The indication light is proper after DVR boots up.
z
Debug after DVR boots up normally.
3.1
Log in
Turn the key to ACC, you can see power indication light becomes on and DVR boots up (DVR boots up
might take several seconds). System is in multiple-window preview mode after boots up and record setup
is continuous record mode. You can see corresponding channel indication light becomes on and record
indication light becomes on too.
After the system boots up, default video display is in multiple-window mode.
Click Enter or left click mouse, you can see the login interface. See Figure 3-1.
System consists of four accounts:
z
Username:
admin
. Password:
admin
. (administrator, local and network)
z
Username:
888888
. Password:
888888
. (administrator, local only)
z
Username:
666666
. Passwords:
666666
(Lower authority user who can only monitor, playback,
backup and etc.)
z
Username:
default
. Password:
default
(hidden user)
For your system security, please modify you password after first login.
You can use USB mouse, front panel, remote controller or keyboard to input. About input method:
Click
to switch between numeral, English character (small/capitalized) and denotation.
Figure 3-1
3.2
Remote Control
The remote control interface is shown as in Figure 3-2.
23