PEX-P32C32/PISO-P32C32U Series Quick Start Guide
ICP DAS CO., LTD.
3
WebSite: http:// www.icpdas.com.tw E-Mail: [email protected] , [email protected]
Step 1:
Shut down and power off your computer.
Step 2: Remove the cover from the computer.
Step 3: Select an unused PCI/PCI Express slot.
Step 4: Carefully insert your I/O card into the PCI/PCI Express slot.
Step 5: Replace the PC cover.
Step 6: Power on the computer.
After powering-on the computer, please finish the Plug&Play steps according
to the prompted messages.
R=10K
O.C.
Out => BSP75N
External
Device
External
Power
(+)
(-) GND
R1
I1
Low Drive
Channel
DC
10V~30V
+
-
Open Collector Output Type & Notice
High Drive channel : Open collector N-channel Power FET (BPS75N) . Max. Sink
Current Is 500mA for Each Cannel .
Low Drive channel : Open collector NPN/PNO Transistor . Max. Sink Current Is
100mA for Each Channel .
(Recommend : It Is necessary to connect a diode In the External Device end as means
of preventing damage form the counter emf . If your External Device Is
inductive Load , Ex. Relay
…
)
R=3.9K
External
Device
External
Power
(+)
(-) GND
R1
I1
D1
High Drive
Channel
DC
10V~30V
+
-
R=10K
O.C.
Out => 2N2222
Sink current
500mA
Sink current
100mA
Diode
External Power (+)
External Power (+)
External Power (-)
External Power (-)
DOn
DOn
-
Diode
PISO-P32S32WU
PISO- C64
P32C32
P32S32WU
External
Device
External
Power
(+)
(-) GND
R1
PISO-P32A32 / PISO-A64
DC
10V~30V
+
-
R=6.8K
O.C.
Out
D
R=10K
I1
External Power (+)
DOn
Source current
100mA
External Power (-)
Low Drive
Channel
If your control device is an inductive load (ex: inductive relay), it is recommended
to connect a diode at the Control Device side as a means of preventing damage
from the counter EMF.
Wiring Note
Installing Hardware on PC
To prevent the board damaged forever by overload, the GND pins (CON1: pin 1/20,
CON2: pin 1/20) all must be connected with GND of External Power.
