I.C.P. Srl
Savannah™ VG
- XL VG
AIRPLANE
MAINTENANCEMANUAL
01-12-51-122
Page 16
Issue 1/Revision 04
ICP Srl
– S.P.16 km 15,150-14022 Castelnuovo Don Bosco (AT)
August 2011
Phone +39-0119927503
•
Fax +39-0119927266
1.3.6 600 HOURS INSPECTION
NOTE: that inspection requires some mid-life engine checks ONLY be carried out as per the
following table:
N.
DESCRIPTION
MECH.
CER. ST.
1
Check the carburettors’ valve play; the valve must be replaced if
the play exceeds 0.5 mm)
2
Check the friction, if installed
1.3.7 1.000 HOURS/72 MONTHS INSPECTION (AIRCRAFT OVERHAUL)
NOTE: The 1000 hours/72 months inspection reqires that a 200 hours inspection (25 hours plus the
50 hours adding checks, plus the 100 hours adding checks, plus the 200 hours adding checks) is
carried out plus the checks AND REPLACEMENTS below started. The aircraft overhaul must be
carried out by the manifacturer or by a specifically approved maintenance facility.
N.
DESCRIPTION
MECH.
CER. ST.
1
Replace all tubes of fuel system
2
Replace all tubes of lubrication system
3
Replace all tubes of cooling system
4
Replace the rubber sleeves
5
Replace propeller’s bolts and nuts
6
Replace accelerator’s cables
7
Replace engine’s silent blocks and nuts and bolts
8
Replace rubber band and inferior guides
9
Replace the bearings of three wheels and anterior wheel pin
10 Replace rubber elastic elements of leaf spring
11 Replace the bushing of command line and all nuts and bolts
12 Replace the connect bushing of all planes (aileron, flap, elevator,
rudder)
13 Dismantle the wings and check the ovalization of hole (max 0,5
mm). Replace all nuts and bolts
14 Dismantle all tailplane and check ovalization of hole (0,5 mm).
Replace all nuts and bolts
15 Replace SD023, SD024 and SD025
16
If not present, install wings connection’s trapdoors and upgrade of
wings connections and bolts and wings connections
1.3.8 1.500 HOURS INSPECTION (ENGINE OVERHAUL)
NOTE: the engine overhaul must be carried out by the engine manufacturer only. In this case
replace the Aluminium engine support.
