3-11
Installing the Driver
5
Start the server.
6
At the NetWare server console prompt, type
load
nwconfig.nlm
and press
Enter
.
7
Select
Driver
Options
and press
Enter
.
8
Select
Configure disk and storage device drivers
and press
Enter
.
9
Select
Select an additional driver
and press
Enter
.
10
Insert the driver disk, then press the
Insert
key.
All available drivers are displayed.
11
Press the
Insert
key again to access additional drivers.
12
Press
Enter
to scan for the drivers.
13
Select
ICP Advanced RAID Controller
and press
Enter
.
The aacraid parameters screen is displayed.
14
Select
Select/Modify driver Parameters
and press
Enter
.
15
Select
Save parameters and load driver
.
16
When prompted to select an additional driver,
select
No
.
17
Press
Esc
to exit the
Nwconfig
utility.
18
Create arrays using the ICP RAID Configuration utility (see
) or remotely using ICP Storage
Manager (refer the online Help). Alternatively, you can create
arrays using the ARCCONF Command Line program. ( see
Installing and Using the Command Line Utility
Now that you have installed the drivers, refer to your NetWare
documentation to modify disk partitions, apply hot fixes, or
perform volume maintenance. See also
.
Loading NetWare Drivers During Server Restart
To automatically load the
aacraid.ham
driver during server restart,
the
startup.ncf
file (usually located in your server's startup
directory) must contain a load command line that specifies the
location of the driver and any appropriate command line options.
