3-10
Installing the Driver
a
select
Modify
when the Storage adapters are displayed.
b
Select Storage adapters and press the
Ins
key to add an
unlisted driver from the floppy disk.
6
When the Device Types screen appears, check the
Storage
adapters
list and select
Modify
to add another driver.
7
Select
Storage adapters
, then press
Enter
.
All recognized controllers are displayed.
8
If
AACRAID
is detected, delete it.
9
Press
Insert
to add another driver. The available drivers are
displayed.
10
Insert the driver disk.
11
Press the
Enter
key to scan the floppy disk drive.
Once the driver is selected, the parameter screen is displayed.
12
Verify the loaded drivers. From the lower window menu, select
Continue
, then press
Enter
.
Note:
If the driver installation process fails, the server
console is displayed so you can see the cause of the failure.
Now that you have installed the drivers, refer to your NetWare
documentation to modify disk partitions, apply hot fixes, or
perform volume maintenance. Also see
for a summary of array
management options in NetWare.
Installing the Driver in an Existing NetWare System
To install the driver in an existing NetWare system:
1
Upgrade your NetWare server to the minimum patch level
specified by Novell.
2
Create the driver disk, as described on
remove the driver disk.
3
Shut down the server.
4
Install and configure the controller as a secondary controller, as
described in
