ICP ICP9014RO, Инструкция по установке и эксплуатации

Страница: 23 / 142

1-12
Introduction
■
NetWare —Acrobat Reader and Viewer are not available for this
operating system or any DOS environment. You need to use a
computer that supports Acrobat Reader or Acrobat Viewer.
Software Tools Overview
The ICP9014RO or ICP9024RO RAID controllers support the
following tools:
■
ICP Storage Manager —Storage management application with
a graphical user interface (GUI). Use this tool to create,
configure, and manage arrays in an environment in which you
have an operating system installed. For details, see Chapters
4
and 5 .
■
ICP RAID Configuration Utility —BIOS-based utility that
contains the following components:
–
Array Configuration Utility (ACU) —Storage management
utility. Use this BIOS-based utility to create, configure, and
manage arrays on a fresh system on which the operating
system has not yet been installed. Also available as a
DOS-based executable (see next bullet). For details on using
the ACU, see
Appendix A . For details on using the DOS-
based ACU, see Appendix B .
– SCSI Select —Device management utility. Used to verify the
hardware configuration of the controller and the drives. For
details, see
page A-9 .
– Disk Utilities —Drive management utility. Used to format
and verify drives. For details, see page A-14 .
■
Array Configuration Utility (ACU) for DOS —DOS utility used
to create, configure, and manage arrays. Also available as part
of the BIOS-based ICP RAID Configuration utility. For details,
see
Appendix B .
■
ICP Flash Utility (IFU) —DOS utility used to update, save, or
verify the controller firmware, BIOS, and ICP RAID
Configuration utility versions. For details, see
Appendix C .
■
ARCCONF Command Line Program —Allows you to create
and manage arrays with ICP RAID Configuration-based ICP
Storage Manager controllers. For details, see
Appendix D .