ZB-2510 Series User Manual, Ver. 1.2 Page 11
kind of application. The method used to implement the above functions in
user-defined route mode is to add a secondary repeater ID number using the
software utility, and then deploy two repeaters in each of the planned
repeater locations.
Repeater ID
01,15 02,16 03,17 04,18
13,27 14,28
Repeater forwarding data
received from the ZigBee
device
00
01
02
03
...
...
12
13
Back up repeater ID
-
15
16
17
26
27
Repeater configuration table 2
The above figure shows an example application and configuration table. If the
repeater with the ID number 02 in the above application is invalid, the data
transmission route will switch to the secondary repeater if the ZigBee
self-detection time has elapsed
(*4)
.
*4: The user can define this value based on the system environment. The
minimum timeout is 4 seconds. The network will attempt to forward the
data to the secondary route if there is a problem with the ZigBee network.